Catalytic Convertor

Hi guys, I have an 02 swift 1.0 and the CAT is knackered and replacement cats are pretty steep, well i have noticed Cats up to 01 are cheaper is it possible to fit one of these? any mods? or whatever. look forward to any advice thts offered cheers, Graeme.

Hi,

Is this the one fitted to exhaust manifold?
If so I have one I don't need so let me know.
We can work out deal!?

Cheers
Atchi

sorry atchi
i have a brand new, never used one for a 3cyl
i was goin to use it to put mine through the mot
but she`s parked up in the garage so i wont be needing it
http://www.flickr.com/photos/11473969@N02/5078929864/
i got it for 80
£50+ postage or pickup, its up to you
regarding the difference`s the expencive ones have a threaded hole just behind the cat for another 02 sensor, if yours has a sensor after the cat then mine will be no good to you and im afraid you`ll have to go for the latter version, or if your good with a welder, you could buy mine and weld it to your existing system

gary

Hi,My cat has both sensors on it and it attaches onto the manifold,so like its the down pipe into the cat then another section of pipe to the centre section, all in one piece. At the risk of sounding like a complete dafty, wasnt sure if it was just a case of drilling a hole and welding a nut to fit my 2nd sensor onto the pipe of an older style CAT.

SHIT

sorry about that i forgot to get pics/prices for postage /DOH

will make sure i have the pics tomorrow. Mine has been used for 6 months. Since i made a total cock up with forgetting about you can have it for £30+ postage

Big,G wrote:Hi,My cat has both sensors on it and it attaches onto the manifold,so like its the down pipe into the cat then another section of pipe to the centre section, all in one piece. At the risk of sounding like a complete dafty, wasnt sure if it was just a case of drilling a hole and welding a nut to fit my 2nd sensor onto the pipe of an older style CAT.

i dont see anything wrong with doing that, its an even better idea than my cut and shuting the old/new cat
it would just be the case of finding the right type of size/thread of nut to weld on

gary

on 2nd thoughts you could cut out the nut off the old exhaust and use it on the new one
heres a better pic of mine btw
http://www.flickr.com/photos/11473969@N02/5081789376/

gary

ermmmm its somehow got damaged and dented while in the garage

must have a ghost or somert