Shitty engine mounts
2 posters
Page 1 of 1
Shitty engine mounts
hey i just put engine in my swift and when i was doing up the bolts to the rear engine mount 1 of the threds in the block was fucked, it tightens a tiny bit then goes loose again so theres is only 3 in there strong and 1 in bit shit do you think it will be ok, im only going to use this engine tempary till i build a new engine, think i might get some lock tight just to hold it in a little more but aint going to do shit ?
maybe buy front strut brace off garndi cus it has extra engine support on it ?
maybe buy front strut brace off garndi cus it has extra engine support on it ?
jesseswiftgti- Posts : 506
Join date : 2010-03-19
Character sheet
first car: 5
Re: Shitty engine mounts
If three are in there and torque up properly you'll probably be OK, Thread lock will do nothing. How long is 'temporarily', If its longer than a month or two pull it out and helicoil it.
GTP
GTP
gtpswift- Posts : 398
Join date : 2009-05-25
Location : Melbourne Australia
Re: Shitty engine mounts
it aint going to be running for about 2 months mate just want to find myself a good block to work with and build it up and put it in
jesseswiftgti- Posts : 506
Join date : 2010-03-19
Character sheet
first car: 5
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum